logo

Case Introduction: XSG-10 Flash Dryer for an Agrochemical Company in Jiangsu, China

January 25, 2026

Latest company case about Case Introduction: XSG-10 Flash Dryer for an Agrochemical Company in Jiangsu, China
Agrochemical production creates some of the most difficult drying duties in process manufacturing. Active ingredients are often heat-sensitive, the intermediate material arrives as a paste, slurry or filter cake, and the finished powder has to meet a tight particle size and moisture specification before formulation. This Jiangsu-based agrochemical company solved those conflicting requirements with an XSG-10 flash dryer, a continuous system that combines drying, grinding and classification in a single unit.
The material challenge

Filter cake from an agrochemical line is not a free-flowing solid. It is cohesive, wet and prone to sticking to hot metal surfaces. In a conventional tray or vacuum dryer, the material is spread on surfaces and stays in contact with heat for a long time, which risks thermal degradation of the active component and produces hard lumps that need separate milling. Batch cycle times are long, and the product quality varies from tray to tray.

How the XSG-10 works

In a flash dryer, wet material is fed into a high-velocity stream of hot air and immediately dispersed. A rotating classifier at the top of the chamber keeps coarse, still-wet particles inside the drying zone by throwing them back into the grinding section, while dried fines pass out with the exhaust gas and are recovered in a bag filter. Because drying, size reduction and classification happen in the same vessel, the product leaves the system as a dry, fine, uniform powder in one pass.

The key process fact in this installation is residence time: the material is dried in about 5 to 8 seconds. That short exposure is what protects the heat-sensitive compounds. The particle never reaches the inlet air temperature; evaporative cooling holds the product temperature well below the degradation threshold while the moisture is removed.
The air distribution detail that made the difference

The dryer is fitted with a specially designed air distribution system that keeps the flow field uniform across the chamber. In flash drying, poor air distribution is the usual cause of uneven drying: some particles recirculate too long and over-dry, others short-circuit and leave wet. A uniform field gives every particle a similar history, so the outlet product has consistent moisture and consistent fineness across the whole batch, not just on average.

Results at the plant

The installation delivered three outcomes the client cared about.

  • No wall sticking: the combination of short residence time and an air-swept chamber prevents the paste from baking onto hot surfaces, which removes a manual cleaning task and a source of contamination.
  • Stable moisture and particle fineness, meeting the specification required for downstream formulation and packaging without a separate milling step.
  • A compact footprint and simple operation compared with a batch train, which reduced labor and start-up time.
Why this configuration suits agrochemicals

The same design logic applies across the agrochemical family: wettable powders, water-dispersible granules, pesticide intermediates and fertilizer blends. Whenever the feed is a filter cake or slurry and the active ingredient cannot tolerate long heat exposure, a flash dryer with an internal classifier gives the shortest possible thermal history combined with an in-line size specification.

What we need to size one

To configure an XSG unit we ask for the material's initial moisture, target moisture, bulk density, particle size requirement, allowable product temperature and required output. A lab or pilot drying test then confirms the achievable capacity and final moisture before the equipment is built.

If you have a similar filter-cake duty, send us the specification and we will propose a model and a test plan.